I've been trying for a few evenings to get blundit to work on my webserver. However I've tried a few different methods but non seems to quite work out for me.
I'm using a raspberry pi 3, debian (buster), php, and lighttpd (with mod_rewrite). I setup lighttpd using this guide https://pimylifeup.com/raspberry-pi-lighttpd/
I've also added the below to the lighttpd.conf file as described here: https://gitter.im/dignajar/bludit/archives/2016/01/08
Code: Select all
url.rewrite-if-not-file = ( "^/bludit/(.*)" => "/bludit/index.php?q=$1" )
Using the rpi script https://docs.bludit.com/en/how-to/easy- ... pi-install seems to run ok, but when I go to the page (for me server.local) it instead shows excerpts of php as if there is a } or ) missing from the script. I've tried finding where the }) is missing and putting it back but this results in a blank page being displayed.
Having removed apache2 and put lighttpd back, I've downloaded the release from bludit and put the contents in /var/www/html/ adjusting permissions to 777. This runs the install, but then gives 404 errors for anything other than the index page /admin and /about show 404 errors.
Finally I've been using the php built-in web server which works no problems, however is only accessible locally, if I change the settings in admin to port 80 they change back to 8000. If I copy the Bludit folder that the php web server downloads from git to /var/www/html/ I also get the 404 errors and due to this cannot edit the web address in the admin page, as I cannot access the admin page. Editing the site.php file to site.local also results in 404 error on any page other than index.
Any advice would be welcomed, I would very much like to use bludit as it seems fairly lightweight and clean in comparison to other CMS I've used.
Thanks!